by disk91 Mon Jul 06, 2015 8:56 pm
Hello, I did not experience bus conflict even if it can be the reason, in fact actually I'm only using accelero at 10Hz and once every 30 seconds so I do not need a large acess to the bus.
What I noticed is where the device is not moving with GPS off, the values returned by Accelero are about +/- 30 but when the GPS is on, the values are moving to +/- 100 so this was impacting my movement detection procedure and sounds not a fully normal behaviour.
I have a workaround for this in my code but as it sounds not normal i'm reporting it.
Paul