Page 1 of 1

UART regression issue on TD1208 chip

Posted: Wed Mar 15, 2017 8:50 am
by dandavid3000
Hello,

I've experienced some issues with UART on TD1208. I developed a firmware to get sensor data over UART for TD1208R, and it ran very well with no issues ( I tested with 2 different sensors).
I managed to flash the firmware on TD1208. However I couldn't get values from sensor. I checked with an oscilloscrope, and knew that the device was able to access (power, and get) sensors, but it read nothing from these sensors.

According to specifications from both TD1208R and TD1208. I couldn't find any differences for UART management. Do I need to configure differently UART for TD1208? What should I do to solve this issue?

I appreciate any help.

Thank you,
Dan

Re: UART regression issue on TD1208 chip

Posted: Wed Apr 12, 2017 3:06 pm
by mstempin
There is no difference between the TD1208 and TD1208R regarding the UART.