Hi,
I am currently routing my PCB for a TD1204.
The datasheet speak about a " No routing wire area" near the RF pin (39,40,41).
Just to be sure, no wires are admitted under this area but I still have to include my ground plane there?
Or do I have to remove all copper on all layers in this area?
I actually have the same question about the UFL connector that I put on my PCB ( 1688077 @ Farnell )
The datasheet tell about a " Cut Out Prohibition Area". Should I put my ground plane in this area?
I am french that why I want to be sure of the translation of those area.
Thanks for yours confirmation.