Problem programming TD1205P with SEGGER JLINK
Posted: Fri Mar 17, 2017 7:51 am
Hello,
I'm trying to flash a TD1205P module with e-commander and a Tiny Geccko board with SEGGER JLINK connection. When trying to remove protection it enters in an endless loop trying to read memory position 400C001C. Does anybody know what could be the reason? Please find attached an screenshot of this issue.
Thank you in advance for any clue.
Regards
I'm trying to flash a TD1205P module with e-commander and a Tiny Geccko board with SEGGER JLINK connection. When trying to remove protection it enters in an endless loop trying to read memory position 400C001C. Does anybody know what could be the reason? Please find attached an screenshot of this issue.
Thank you in advance for any clue.
Regards