I'm using a TD1208EVB and I am trying to send a SigFox message but I keep receiving the Error message. The firmeware loaded is the last version : td1208_modem_SOFT1451.bin
The thing is that, when I received the board last week, I tried the "Cloud-on-Chip™ Transmission Test" and it worked. Now that my SigFox backend account has been created, I tried the "SIGFOX™ Transmission Test" but it is not working. Also, the "Cloud-on-Chip™ Transmission Test" is not working anymore and I keep getting the Error message for both of them.
For the AT&V command, I receive :
- Code: Select all
Telecom Design TD1208
Hardware Version: ??
Software Version: SOFT1451
S/N: FFFFFFFF
ACTIVE PROFILE
E1 V1 Q0 X1 S200:0 S300:24 S301:2 S302:14 S303:1 S304:20 S305:25 S350:0 S351:327
68 S352:1 S353:10 S400:000000 S401:FFFFFF S402:0 S403:869412500 S404:14 S405:32
S406:1
I am pretty sure that last week, the Hardware Version was something like 0F and the S/N was 0000XXXX ending with the serial number of my board...
The only thing I did since then is programming the board with the blinking example project from Eclipse. I first loaded the binary file using the TDLoaderV1.06 and then, I managed to program it and launch a debug session with a J-Link debugger. I played with the J-Flash Lite tool (erasing the flash and programming the chip again).
Thank you for your help.