Questions and discussions about the software that runs on the TD RF module itself.
chertu
 
Posts: 3
Joined: Mon Jul 13, 2015 5:55 am

Problem combining GPS and RF messages

by chertu Mon Jul 13, 2015 5:58 am

Im having some problems with my TD1204 module.

I want to constantly send RF messages that contain location information, so im using the AT$GPS commands for getting the location information an then sending it with the AT$SF command, with some other additional info. These are the stepts I am following

I get the location info using “AT$$GPS=1,16,0,65535,2,1” and when the RMC frame has a fix value, put it in backup mode with “AT$GPS=2”.
Then I send a message with AT$SF
(The module is ON all the time)
The problem comes when I call again to the “AT$$GPS=1,16,0,65535,2,1” command, intead of getting an OK and start to see the NMEa frames, the module always restarts (I get a ^SYSSTART). That supposes a problem because I want to keep the GPS on backup mode so the fix time is the minimum possible.

Why is this happening?

Regards,
Return to Firmware

Who is online

Users browsing this forum: No registered users and 28 guests