Hello,
I checked with my firmware (built on SD 6.3.4) - and Sigfox project from TD on TD1508. - I set dBm = 15
With Enegy Micro enegyAware Proiler I got
TX = 77 mA
RX = 66 mA
With Amperemeter TENMA 72-7730A I got
TX = 85 mA
RX = 66 mA
According to TD1508 Data sheet. They should be TX = 135 mA, and RX = 21 mA (low active radio power consumption). The result I obtained above was really high for RX
when I set dBm = 14 (I know this one is not correct)
Here's the result I got
TX = 110 mA
RX = 66
I'd like to know when I set dBm = 14 then what device is going to do ?
Could you please help me to check this, and guide me if I missed something ?
Dan