Questions and discussions about the software that runs on the TD RF module itself.
dandavid3000
 
Posts: 24
Joined: Fri Oct 28, 2016 12:30 pm

SDK functions to disable FCC rules

by dandavid3000 Thu Dec 01, 2016 11:25 am

Hi,

I would like to ask if there is any function I can use to force the TD1508 to send all its messages on a desired macro channel?
I'm working with TD1508 and Sigfox network emulator, and I can only receive the first 2 messages shown on snek.
Due to the frequency hopping for FCC compliance. FCC rules force the devices to operate on 50 micro channels of 25KHz. The 2 first messages (2*3 frames) are sent on the default macro channel, and the 16 following messages are sent on the 8 other 192KHz macro channels if nothing specific is done.

Many thanks,
Dan
dandavid3000
 
Posts: 24
Joined: Fri Oct 28, 2016 12:30 pm

Re: SDK functions to disable FCC rules

by dandavid3000 Mon Dec 05, 2016 3:16 pm

I tested with AT command "ATZ" to reset the module after sending every 2 messages, and it worked ! Is this the proper way to deal with FCC rules ?
What is the function in SDK 6 for sending "ATZ" command to TD1508 ?

Thank you,
Dan
User avatar
mstempin
 
Posts: 168
Joined: Thu May 07, 2015 9:24 am

Re: SDK functions to disable FCC rules

by mstempin Wed Dec 14, 2016 4:39 pm

Yes, this is the way to do it, and it is possible either using AT commands, the C API or the hardware reset pin.
Return to Firmware

Who is online

Users browsing this forum: No registered users and 24 guests