Hello,
I have an issue using the TD1208 when I am reading sensor values via I2C.
Everything works perfect when I flash the firmware (which includes a reset via the reset pin).
However, when I power cycle the device (disconnect wires for power and reconnect), the program does not run properly.
On the scope, the SCL and SDA lines both suddenly return from low (pulled down) to high (released).
Depending on slight changes in the code, this moment occurs in the somewhere during the sending of the device I2C bus address.
In my last test, this was during the 6th clock cycle.
Does anyone have a similar issue like this (different I2C behaviour for power cycle vs reset pin toggle)?