Hello,
I am trying to set the CW mode in my FW for a TD1204 module, but I think I need some assistance.
I found a function :
void TD_SIGFOX_TestCarrier ( uint32_t level, uint32_t frequency, bool high_performance )
which I think could do the job, but not sure.
I tried it and I got a hard fault message through the serial port (see attached picture). but maybe it is only due to a bad parameter...I dont know.
From other post (viewtopic.php?f=3&t=114) I saw we should use AT command :
AT$MT=x,2,0
But I could not find such command in the SDK and see which is the function to use.
Which function should I use for both TD1204 and TD1208 turining in CW mode?
Is it an infinite function or shall i call it periodically?
Thanks in advance !
Regards, Ramon.